Ryobi USB Lithium or TEK4 Battery Holder Garage, shop, mancave, organizer tool

Description: Ryobi USB Lithium or TEK4 Battery Holder These hold Ryobi USB Lithium and TEK4 (4v) batteries at a 45-degree angle and can be mounted on the wall, pegboard*, or Ryobi Link Wall Rails. By storing batteries at a 45-degree angle, they are easy to grab and stay relatively close to the wall, pegboard*, or Link Wall Rails. There are versions that hold either 6 or 12 batteries. Each includes 6 pegs: 3 curved and 3 straight that are recessed on the back. There are slots at the top and bottom of each location to allow for a USB-C charging cable to be connected to the batteries while stored. The top and bottom rows can be plugged in to charge while all slots are filled with batteries. The slots also allow TEK4 (4v) batteries to be installed to accommodate the notch on the side. With batteries in all the slots, the overall height does not exceed the height of 1 Ryobi Link Wall Rail (no protrude below it). The width of the 12-battery version does not exceed the midpoint between the next slot on the Ryobi Link Wall Rail, thus 2 may be mounted side-by-side. Thus if mounted on Ryobi Link Wall Rails, these are as efficient as possible. If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place. NO batteries are included and shown in photos are for reference only. * Note that there are many different types of pegboard and some may not work. This was designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only. It is 3D-printed in PLA plastic. The 6-battery version is 2.5" x 2.3" x 4.75" (63mm x 59mm x 121mm). The 12-battery version is 4.75" x 2.3" x 4.75" (121mm x 59mm x 121mm)

Price: 13.95 USD

Location: Lexington, Kentucky

End Time: 2024-02-04T16:29:11.000Z

Shipping Cost: 0 USD