John Deere 4010, 4020 LOAD SHAFT SEAL MASTER KIT "Best JD Fix" Free SHIPPINGUSA

Description: © AP6.0 John Deere Heavy Duty Load Shaft Seals PLUS one pair of Load Shaft Bushings with Orings STOP THE LEAK!!!! You are buying one pair of seals and one pair of bushings! You are bidding on *** two *** (2) load shaft seals modified with a new heavy duty seal to stop load shaft leaks on your 4000, 4010, 4020, 5010 or 5020 hitch. Also fits Industrial 600 and 700. 4020 serial must be below 250,000. Later models have a larger load shaft. You will need two seals to do both sides! Replaces Deere AR87492 kit which a dealer would hand you. The seal in that kit is AR26414. This is a very good fix for a problem area on Deere hitches. It is my best fix to date. The seal is replaceable and can be purchased from Deere. The Seal holder is made by on a CNC machine in a shop in Michigan with great quality control. They are USA and they are right. This package includes both the inner and outer seals. There is a private repair shop in the Michigan Thumb area that got me working on this project. They work on Deere all day every day. A few instructions are included. Basic knowledge of the load shaft and seals helps. This job is not a simple one. If you do not have experience removing the load shaft I suggest you hire a Deere technician to install these parts for you. Getting the Teflon seal into the seal holder is harder than it looks. Stuff the seal in place then use a smooth steel rod to work the Teflon seal flat into the seal holder. Do this before you put the seal holders into the tractor case. If you ruin a Teflon seal, they are in stock at all Deere dealers. I give you the part numbers in my paperwork. Made in USA with as much effort and care as we could find. Here is a testimonial from a fellow Deere owner: Dear patspartsstore, I just finished installing your kit. fit was perfect inner and outer, i also believe this to be superior to factory. When i installed my kit, i took the drawbar support completley off. The front bushing was terribly wore, 1/4-3/8ths inch slop, never replaced in 53 years, 4010. Without replacing this bushing i think the seals in a short time would leak again from the slop, this support is very easy to R and R. I also think you should send out your kits with the teflon seal and oring installed, but a vice grip very, very gently clamped held the teflon seal to make installation a breeze. thanks Shipping on this item is free(USA only)USPS Ground Advantage. For a small fee we will ship using priority mail. Thanks Pat and Barb...you can trust us <><

Price: 140 USD

Location: La Porte, Indiana

End Time: 2024-11-16T17:21:21.000Z

Shipping Cost: N/A USD