HELIX M FOUR 4-Channel DSP Amplifier + Helix M ONE X-SUBW amplifier BRAND NEW

Description: BRAND NEW HELIX M FOUR DSP AMPLIFIER+HELIX M ONE X SUBWOOFER AMPLIFIERTHIS COMBO OF AMPLIFIERS WILL OUTPUT 10 CHANNELS AMPLIFIED WITH DSP PROCESSING 1 YEAR WARRANTY Technical dataPower RMS ? 1% THD+N - @ 4 Ohms4 x 100 Watts - @ 2 Ohms4 x 100 Watts- @ 1 Ohm- - bridged @ 4 Ohms2 x 200 Watts- bridged @ 2 Ohms- Max. output power per channel*Up to 135 Watts RMS @ 4 / 2 OhmsAmplifier technologyClass DInputs6 x RCA / Cinch6 x Highlevel speaker input1 x Optical SPDIF (12 - 96 kHz)1 x Remote InInput sensitivityRCA / Cinch 1 - 4 VoltsHighlevel 5 - 20 VoltsInput impedance RCA / Cinch22 kOhmsInput impedance highlevel9 - 33 Ohms or 20 kOhmsOutputs4 x Speaker output6 x RCA / Cinch2 x Remote OutOutput voltage RCA / Cinch6 Volts RMSFrequency response20 Hz - 22,000 HzDSP resolution64 BitDSP power295 MHz (1.2 billion MAC operations/second)Sampling rate48 kHzDSP typeAudio signal processorSignal convertersA/D: AKM 32 BitD/A: AKM 32 BitSignal-to-noise ratio digital input105 dB (A-weighted)Signal-to-noise ration analog input102 dB (A-weighted)Distortion (THD)< 0.03 % Damping factor100Operating voltage10.5 - 16 Volts (max. 5 sec.down to 6 Volts)Idle current1500 mAMax. remote output current500 mAFuse2 x 30 A Maxi-fuse (APX)Additional featuresADEP.3 circuit, Auto Remote switch, 32 Bit CoProcessor, Control InputDimensions (H x W x D)50 x 230 x 154 mm /2.00 x 9.06 x 6.06?CONTENTS: 1 x Amplifier HELIX M FOUR DSP1 x USB cable1 x Mounting material1 x Instruction manuaL HELIX M FOUR DSPThat rocks ? the new M FOUR DSPThe M FOUR DSP is more than ?just? another four-channel amplifier ? rather, despite its small dimensions, you are dealing with a powerful control center that has not less than a total of ten processed DSP channels. In addition, the amplifier delivers plentiful output power with generously 100 Watts RMS per channel into both 4 Ohms and 2 Ohms load.Finally its awesome price performance ratio in combination with the fantastic feature set will ensure bright eyes. Tonally absolutely HELIX!Compromises in terms of sound quality have no place in a HELIX product ? and that's why the M FOUR DSP is equipped with all the finesse for perfect sound. Of course, excellent and separate AD and DA converters are just as natural as on the DSP circuit board, which is completely manufactured in Germany, you will find only excellent, separate AD and DA converters as well as an extremely powerful DSP from Analog Devices. In addition, the six pre-amplifier outputs with 6 Volts output voltage provide more than enough level to drive any additional amplifier. Maximum flexibilityEven the internal amplifier section of the M FOUR DSP is extremely variable ? it can either be operated in 4-channel mode or, thanks to its bridging capability, can also be configured as a 3-channel or even 2-channel amplifier.But that's not all ? in connection with the six pre-amplifier outputs, the sound system can be expanded in a diverse manner and upgraded to up to 10 channels.In combination with other amplifiers of the M series (M ONE X, M FOUR or M SIX), there are more than enough possibilities to expand the number of power channels.This makes complex, yet affordable and, above all, space-saving multi-channel systems with enormous performance possible. Virtual Channel Processing ? that´s how signal routing works todayMany DSP channels need to be managed and configured properly ? so there was no question that the M FOUR DSP is also equipped with Audiotec Fischer's innovative virtual channel processing.The adaptation to modern OE sound systems via an increasing number of inputs has a significant impact on the complexity of the signal routing inside the amplifier. Especially when several input signals are mixed together and then split again into multi-way systems, conventional routing concepts quickly reach their limits, both in terms of implementation and usability. Audiotec Fischer's new multi-stage "Virtual Channel Processing", in conjunction with the recognized user-friendly DSP PC-Tool software makes it easy to realize even highly complex system configurations. Besides, it allows to freely assign our proprietary FX sound features such as "RealCenter" or "Augmented Bass Processing". The plus in speed ? thanks to ACOFaster is better ? the particularly powerful 32 Bit ACO platform takes over all control tasks and ensures significantly more speed, especially for data communication with our DSP PC-Tool software but also for the lightning-fast switching between up to ten sound setups. But ACO offers much more ? fantastic sound effects such as Augmented Bass Processing or RealCenter are implemented as well as a channel-separated Input EQ including the Input Signal Analyzer (ISA) for easy analysis and compensation of input signals of OE radios that already include an ?ex works? sound setup. Compact, cool and absolutely practicalDespite its vast range of functions and huge output power the M FOUR DSP presents itself in the same classic, compact HELIX design with distinctive lines like a HELIX M FOUR or M ONE. Thanks to its Class D amplifier technology, it keeps a "cool head" even at full power. And thanks to features such as start-stop capability, ADEP.3 circuit and power save mode, it is also ideally equipped for the now everyday challenges of OEM integration. FEATURES:Up to 135 Watts RMS max. output power per channel into 4 & 2 ?Extremely powerful 64 Bit ?fixed point? Audio DSP and state-of-the-art 32 Bit AD and DA signal converters from AKMACO ? Advanced 32 Bit CoProcessor platform for enhanced system and DSP features like:ISA (Input Signal Analyzer) and InputEQ for easy analysis and compensation of input signalsSFX sound effects ? Augmented Bass Processing, StageXpander, RealCenter & Co.Smart 6-channel highlevel input with ADEP.3 circuitSix RCA / Cinch line outputs with max. 6 Volts output voltageVirtual Channel Processing (VCP) allows even more flexible configuration for highly complex sound systemsBridgeable amplifier channels for driving powerful woofer or subwooferDSP-board manufactured in GermanyDSP features RealCenterThe ?RealCenter? feature is an algorithm, developed by Audiotec Fischer, that emphasizes the music information which is present in both the left and right front channel to create an unique center signal. In contrast to common procedures, in which only the channels are summed up, the intensity of the center signal is also dynamically controlled by the stereophonic informational content of the left and right channel.Sounds complicated but this effect is astonishing: That means if solely the left or right channel delivers an audio signal, the center channel will not reproduce a signal. In the case of common algorithms, the volume level of the center channel is only reduced by 6 dB (= half volume level). Audiotec Fischer?s ?RealCenter? allows a unique, broadened sound staging for both driver and co-driver at the same time! Therefore, the disadvantages of a conventional center channel, such as an intrusive, small sound stage, are things of the past. Augmented Bass ProcessingAudiotec Fischer?s proprietary ?Augmented Bass Processing?, consisting of the two revolutionary sound features ?Dynamic Bass Enhancement? and ?SubXpander?, has been especially developed to dramatically improve the bass reproduction of subwoofers.The ?Dynamic Bass Enhancement? ingeniously combines maximum deep bass and highest sound pressure ? regardless of the music style or the tone controls in the head unit. Depending on the input signal, the ?Dynamic Bass Enhancement? gains the lower frequency range and varies the cut-off frequency of the subsonic filter. The result is a significantly more powerful and deeper bass response at low and medium volume levels without the risk of overloading the subwoofer neither mechanically nor electrically at high volume levels. It is simply fascinating which bass performance is suddenly possible.If you want an even lower and ?darker? bass reproduction, the ?SubXpander? can be additionally activated. Therefore, subharmonic tones are added to the fundamental tones in the frequency range between 50 and 100 Hz. StageXpanderDepending on the speaker arrangement in the vehicle, a more or less wide stereo sound stage can be created on the front seats. A center speaker may limit the spatial reproduction of the music additionally. This is where Audiotec Fischer?s new ?StageXpander? comes into play ? a sound feature which seems to break the acoustic limitations and thus allows to create a way broader stereo base without negatively affecting the precision of the localization of voices or instruments!The effect can be adjusted according to your personal preferences in four steps. ClarityXpanderYou are looking for more transparency and substance in the treble reproduction? With the ?ClarityXpander? Audiotec Fischer is now offering the right tool. Properly adjusted (and therefore selectable in three steps) the feature adds additional harmonics in the upper frequency range ? this is especially useful if the original speakers lack some brilliance in the treble response. The extra treble-kick is not only available for the two front channels but also separately adjustable for the center channel. Even better ? the center channel allows to activate an automatic and dynamic control so that music with ?loads? of treble doesn?t fatigue your hearing. HELIX M ONE XSmall, efficient and uncompromisingly stable - the M ONE X is a highly compact monoblock for subwoofer applications. Designed from latest Class D technology this tiny amp can easily control speakers with 1 Ohm impedance. Its current capability makes the M ONE X a perfect partner for 2 x 2 Ohms subwoofers, where both voice coils are connected in parallel. And for even more output power, two M ONE X amplifiers can be combined to one single powerhouse ? thanks to the TwinPower Link.In addition a comprehensive and stunningly practical feature set leaves nothing to be desired. Last but not least installation will be a no-brainer due to the minimal dimensions.FeaturesSmall footprint Class D amplifier with up to 1,180 Watts RMS output power @ 1 Ohm for easiest combination with all 2 x 2 Ohms subwoofers connected in parallelStart-Stop capability down to 6V supply voltageSmart highlevel input with ADEP circuit and Auto Turn-On functionIntegrated, active crossover with lowpass, bass boost, subsonicand phase controlTwinPower Link for connecting two amplifiers in bridged modeBass remote control for volume adjustmentLow heat dissipation thanks to extraordinary efficiencySpecial featuresSmart highlevel inputThe latest generation of OE car radios incorporates sophisticated possibilities of diagnosing the connected speakers. If a common amplifier will be hooked up failure messages and loss of specific features (e.g. fader function) quite often appear - but not with the M ONE X.The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily.Start-Stop capabilityThe switched power supply of the HELIX M ONE X assures operation even if the battery?s voltage drops down to 6 Volts during engine crank.Technical dataPower RMS ? 1% THD+NNormal operation(One amplifier)TwinPower Link(Two amplifiers)- @ 4 Ohms1 x 400 Watts 1 x 1,400 Watts- @ 2 Ohms1 x 700 Watts1 x 2,060 Watts- @ 1 Ohm1 x 1,030 Watts- - bridged @ 4 Ohms-- - bridged @ 2 Ohms-- Max. output power per channel*:Up to 1,180 Watts RMS @ 1 OhmAmplifier technologyClass DInputs2 x RCA / Cinch2 x Highlevel speaker input1 x Remote In1 x Remote control inputInput sensitivityRCA / Cinch 0.5 - 6 VoltsHighlevel 1.1 - 13 VoltsInput impedance RCA / Cinch20 kOhmsInput impedance highlevel9 - 33 OhmsOutputs1 x Speaker outputOutput voltage RCA / Cinch- Signal converter for digital input- Frequency response10 Hz - 250 HzBass boost0 - 12 dB / 30 - 80 HzHighpass- Lowpass50 Hz - 250 Hz adjustableBandpass10 Hz - 250 Hz adjustableSubsonic10 Hz - 50 Hz adjustablePhase0 - 180° adjustableSlope high- / lowpass- Slope subsonic / lowpass12 / 24 dB/Oct.Signal-to-noise ratio digital input- Signal-to-noise ratio analog input95 dB (A-weighted)Distortion (THD)0.20 %Damping factor150Operating voltage10.5 - 16 Volts (max. 5 sec. down to 6 Volts)Idle current800 mAFuse3 x 40 A Maxi-fuse (APX)Additional featuresActive, adjustable crossover, bass boost, phase shift, Start-Stop capability, highlevel input with automatic turn on function and Advanced Diagnostics Error Protection (ADEP), bass volume cable remote control Dimensions (H x W x D)50 x 320 x 154 mm /2.00 x 12.60 x 6.06?* In typical applications as subwoofer amplifierScope of delivery1 x Amplifier HELIX M ONE X1 x Cable remote control1 x Mounting material1 x Instruction manual

Price: 1299 USD

Location: Brooklyn, New York

End Time: 2024-04-03T00:32:14.000Z

Shipping Cost: 69 USD