FV600 Oxy/Fuel Adapter to Connect an MC Regulator (CGA200) to a Disposable Fu...

Description: FV600 fuel valve adapter is used to connect a MC acetylene regulator (CGA200) to a disposable fuel cylinder (CGA600). All acetylene regulator diaphragms and seals are for use with propylene, Zapp Gas or propane fuel gas. Warning: Fuel compatibility with other manufacturer's acetylene regulators must be determined prior to use. The 71 welding handle and Type17 weld/braze tips will work properly using either of the fuel gases combined with oxygen. The CA550 cutting attachment will also work with wither fuel gas. However, the cutting tip is fuel specific and must be changed. Also, 's Cap'n Hook tips are fuel specific. It is recommended to use "T" hose (part# H32AT) with propylene, Zapp Gas or propane fuel gas. If using "R" hose (part# H32A) with propylene, Zapp Gas or propane fuel gas, it must never be used in extremely cold temperatures below -10 degrees F. This may cause the fuel gas to liquefy and act as a solvent that will attack the internal hose material. Always bleed off the remaining fuel gas in the hose after each use. NOTE: There will be a noticeable performance and temperature difference when using propylene, Zapp Gas versus acetylene and an increase in oxygen consumption. Acetylene burns at 5589 degrees F with an oxy/fuel ratio of 1-1 respectively. Zapp Gas burns at 5193 degrees F with an oxy/fuel ratio of 3.5 - 1. Propane burns at 4579 degrees F with an oxy/fuel ratio of 4 - 1. It is highly recommended to use a Type17-3 or larger tip for brazing 3/8" and 7/8" copper line sets. Fuel valve adapter to connect acetylene MC regulator to a disposable fuel cylinder Connects CGA200 to CGA600 Fuel compatibility with other manufactuer's acetylene regulators must be determined prior to use Plastic tote, regulators, tanks, and hose not included Proudly made in the U.S.A

Price: 38.78 USD

Location: Rocky Hill, Connecticut

End Time: 2024-11-30T03:19:45.000Z

Shipping Cost: 0 USD